Roxell Minimax Line, Use And Assembly Manual

Page: 65 / 94

ROXELL - 001 - 2112 MINIMAX LINE -- INSTALLATION INSTRUCTIONS
III--13
PROCEDURE :
-- First determine the position of the feeder lines.
-- Then measure the distance from the wall to the first feeder line.
-- Mark from this spot the suspension points on the ceiling over the whole length of the line.
-- EACH SUSPENSION POINT (SMALL PULLEY) SHOULD BE ABLE TO HOLD A LOAD OF 100KG .
-- THE FIXING OF THE HEAVY DUTY PULLEY (100KG HOPPER) SHOULD BE ABLE TO HOLD 300KGS.
SUSPEND THE CONTROL UNIT AT LEAST 3M FROM THE HOUSE END WALL !
CENTRAL WINCH
Turn screw hooks every 3--3,5m into the girders of the
roof on the marked line.
Screw hook openings point away from the central winch.
FIGURE 31.
MAKE SURE SUSPENSION POINTS ARE WELL ALIGNED !!!
Wooden beam.
Beam Suspension cord
Main cable 5mm
Screw hook with pulley.
If H more than
3m.
(L = 3M)
FIGURE 32.
H
If winching--up height (H) exceeds 3m, place suspension hooks crosswise off the beam center line. So the cable clamps
will not touch the pulleys when you wind up the line.
(Max. 3,5M)
FIGURE 33.
You will not get any differences in level along the line as long as you respect
the distances at the first two cable attachments.
Cable
Feeder line.
25cm 15cm 25cm 25cm 25cm 15cm 15cm 15cm 0cm 0cm
If lifting height is more than 3m, you can install the central winch somewhat out of line. So the pulleys will not touch the
cable clamps. (Alternative system : see Fig. 32.)