Roxell Minimax Line, Use And Assembly Manual

Page: 67 / 94

ROXELL - 001 - 2112 MINIMAX LINE -- INSTALLATION INSTRUCTIONS
III--15
FIGURE 37.
-- Guide the main cable through the winch.
-- Hook the cable on the drum flange.
-- Make 4 full turns on the drum, guide the cable
against the drum flange and make sure that
windings touch each other.
-- Pull the main cable through the bottom hole of the
drum.
-- Always connect the main cable
with two cable clamps.
-- Hook the cable over the recess in the drum (if necessa-
ry use a screw driver and a light hammer).
-- Fix the cable with a set screw. See that you do not dam-
age the cable by tightening too much.
-- Make 4 full turns on the drum,
guide the cable against the drum
flange and make sure
that windings touch each other.
-- Always fix the main calble
with two cable clamps.
-- Stretch the main cable by using counterweights
(e.g. : power units).
A
B
Set screw.
Recess in the drum.
-- Now you can start the complete suspension of the system
-- Start at the end of the circuit.
-- Hang the roll of cable in a support to prevent torsion when unrolling the cable.
-- Pull the cable through the first pulley.
-- Unroll the cable towards the winch until you have the required length.
TO INSTALL THE MAIN CABLE
CONSIDER THE DOUBLE DIVERSION !! ONLY THEN INSTALL THE CABLE. YOU CAN HANG THE
MAIN CABLE IN THE SCREW HOOKS FOR THE TIME BEING.
AFTER INSTALLING THE SUSPENSION CABLES, MAKE SURE THAT THE CABLE RUNS ALONGSIDE
(NOT THROUGH) THE SCREW HOOKS AND THE PULLEYS. THE MAIN CABLE RUNS ONLY THROUGH
THE HEAVY DUTY PULLEYS AND THE PULLEYS AT BOTH ENDS OF THE CIRCUIT.