Roxell Minimax Line, Use And Assembly Manual

Page: 74 / 94

MINIMAX LINE -- INSTALLATION INSTRUCTIONS ROXELL - 001 - 3911
III--22
TO INSTALL THE AUGER
ALWAYS USE SAFETY GLOVES WHEN YOU WORK ON THE AUGER !
Always use hard solder. We recommend a bronze, flux--coated rod. The joint
must be well filled. Avoid sharp edges or rough corners : these wear out the
tubes. Braze at low temperature.
Weld length.
Min.
1
/
4
of the auger circumference, up to Max.
1
/
3
of the auger circumference.
Remove all wires, labels etc... from the auger.
If the auger is kinked or bent: straighten it by plying it
over the upper leg.
FIGURE 56. FIGURE 57.
TAKE CARE THAT THE AUGER
DOES NOT UNROLL !
If you can’t straighten the auger, cut out the kinked part.
Then braze the auger according to our instructions.
! KINKS OR DENTS WEAR OUT THE TUBES !
AUGER BRAZING
Firmly clamp the auger in an angle
or channel iron.
FIGURE 58.
Allow the joint to air cool. Rapid cooling makes the joint brittle and breakable.
MAX. 1/3
MIN. 1/4
MIN. 1/4
MAX. 1/3
OPTION : USE OF THE AUGER INJECTOR KIT : SEE PAGE III-38
Remove the anchor from
the feed intake boot.
FIGURE 59.
Put the auger coil about 4m from the feed intake boot.
Gradually unroll while giving short pushes to slide the auger
into the tube.
FIGURE 60.
4M