Rowe CD-100K LASERSTAR STARGLO, Installation Manual

Page: 35 / 165

CD-100K Phonograph
2 - 1 0 21822666
11. Move down to the next play option (LEVEL 2 PLAYS) by pressing and holding RESET and then pressing
1 (enter 009 and press POPULAR).
12. Move down to the next play option (LEVEL 3 PLAYS) by pressing and holding RESET and then pressing
1 (enter 025 and press POPULAR).
13. Move down to the next play option (LEVEL 4 PLAYS) by pressing and holding RESET and then pressing
1 (enter 000 and press POPULAR).
14. Move down to the next play option (LEVEL 5 PLAYS) by pressing and holding RESET and then pressing
1 (enter 000 and press POPULAR).
CHECKING THE PRICING
Add bills (and coins, if a coin acceptor is installed) to reach the first (or next) price level. Check for proper credit
at each price level.
SOUND SYSTEM SETUP
If you are not using extension speakers, skip to Section 9 and setup the AUDIO EQUALIZERS.
Extension Speaker Operation
To avoid a poor sounding jukebox, care must be taken when adding extension speakers. Two requirements must
be met:
1. Speakers must be wired so that the power consumed by the jukebox speakers and extension speakers
does not exceed the amplifier power rating. After wiring the speakers, perform an Amplifier Overload
Check.
2. All speakers must be connected with the correct polarity.
Several charts have been included to assist you with connection of the extension speakers.
Figure 3-7 shows the entire sound system.
NOTE:
Channel 1 output phase is reversed with respect to channel 2. This reversal is necessary
to extend monaural sound in a stereo jukebox system. Because of this reversal, speaker
connections to channel 1 must be reversed when compared to channel 2, except for 70 V
speaker connections. The 70 V phasing is reversed inside the output transformers. See
figure 3-7 for correct polarity hookup of extension speakers. If the (+) and (-) terminals
are not wired properly, the speakers will be out of phase, causing a reduction in low
frequencies (bass).