6
x
Operation
81
FA ROTEX HeatPumpSolarUnit - Part 2 - 05/2009
Reading switching times
1.
Use the
key to select the operating mode to be programmed.
2.
Use the
key to confirm the selection.
The selected operating mode flashes.
3.
Use the
key to confirm the selection again.
The current day flashes.
4.
Use the
and
keys to select the weekday to be
programmed.
The selected weekday flashes.
5.
Use the
key to confirm the selection.
The first switching time program of the selected weekday
flashes.
6.
Use the
and
keys to move to the other switching
times for this day. Empty switching times are not displayed.
Programming switching times
7.
Hold the
key pressed for 5 s.
8.
Use the
key to select the switching time number to be
programmed.
9.
Use the
key to switch between the following entry methods:
–
: Room heating, room cooling
1)
are switched off.
–
: Room heating, room cooling
1)
and control system are
switched on. Use the
and
keys to set the
temperature.
–
: Room heating is operated on the basis of the weather-
dependent target value calculation.
10.
Use the keys
and
to set the corresponding start
time.
11.
Repeat steps 8 to 10 to program the other switching times or to
change to the highest switching time of the current day (see step 6).
Then continue with step 12 to complete programming.
12.
Hold the
key pressed for 5 s.
Current switching time is displayed.
The current switching time and all switching time below that
are saved. All switching times above the current switching time
are deleted.
Fig.6-4
Read and program switching times
• You can program the next weekday by pressing the
key once after step 12.
• By pressing the
key several times, you can return to the previous programming steps. Normal
operation is then active again if the
key has been pressed often enough (until before step 1).
