89
User manual
Hydrobox module AQMS80X1i
EN
PART 2. INSTALLATION MANUAL
7.3.3. Remote switch function
„CN400” terminal is used for remote ON-OFF switch; when using this function, this interface is connected to
external control switch, remove the short connector of JR400 when you use the „ON-OFF” function.
The control logic is as follows:
• Remote switch short circuit: the machine is controlled as normal.
• Remote switch off: the machine enters remote control.
1. The battery is placed in the accessory bag and needs to be installed in the wired controller on site.
2. Please remove the wired controller, place the battery in the unit and ensure the positive side of the battery
is in accordance with the polarity markings.
3. Set the correct time before operating. Battery in the wired controller can maintain the correct time during a
power failure. When the power is restored and the displayed time is not correct, replace the battery.
7.4. Dip switch function
DIP switch
Function
OFF
ON
Default setting
SW1
SW1-1
-
-
-
OFF
SW1-2
TW1B
WITHOUT TW1B
WITH TW1B
OFF
SW1-3
TH
WITHOUT TH
WITH TH
OFF
SW1-4
TK
WITHOUT TK
WITH TK
OFF
NOTE: Slide the switch to numbers
position indicates “OFF”.
7.5. Battery installation
NOT
E :
1. Special power supply shall be used for the hydraulic module, and the power supply voltage shall conform to the
rated voltage.
2. The power line ground wire of hydraulic module must be reliably connected with the effective ground wire of
external power supply.
3. Wiring construction must be carried out by professional technicians according to the circuit icon.
4. The connected fixed line must be equipped with a full pole disconnecting device (e.g. air switch or Leakage
protection switch, etc.).
5. In accordance with the requirements of relevant national technical standards for electrical equipment, leakage
protection devices shall be set up.
