Conditions
READ THIS FIRST
Please pay attention to the following installation and safety recommendations:
Read the installation manual before installing this system.
NOTE!
Please make sure your installation location has enough room
and access to a 220v power supply.
Incoming Water
Incoming water pressure must be between 10 PSI and 100 PSI. Test your water occasionally to make
sure the system is performing. If your water is microbiologically unsafe or of unknown quality do not
use this system without adequate disinfection before or after the system. Extremely hot or cold
incoming water will damage the system and cannot be used.
Your Untreated Water Inflow quality will
determine your needs for pretreatment and filtration.
Leaks
Inspect all connections after the installation to make sure no leaks occur, wait until after the system is
pressurized to inspect again. Check the system occasionally after installation or maintenance to make
sure no leaks have developed. Install the system in a location with adequate drainage.
General
This KSRO System is for climate-controlled indoor use only. Exposure to overly high or low-temperature
ranges will damage the unit. Follow all of your state and local laws and codes regarding plumbing even
if they differ from what is stated in this manual. If your state law requires it or you prefer to we
recommend using a professionally licensed installer or plumber who meets the requirements of this
system. All O-Rings, fittings, filter canisters, and Teflon tape wear out after a certain period. The lifetime
of your components is subject to change with the quality of the water supplied. Do not handle an
unwrapped filter directly with your bare hands as this can cause early filter failure. Use appropriate eye
protection when performing any drilling.
Maintenance
The owner/user is obligated to properly inspect and maintain the KSRO System when necessary, at least
every 1 year. This includes the following:
The O-Ring on the filter housing, membrane vessel, booster pump, solenoid valve diaphragm, and
fittings.
Replace any connectors and filter housings with proper replacement parts.
Sanitize your system as often as needed (this changes with the profile of your area’s incoming water).
Always use proper replacement filter cartridges with the correct size and length replacements.
Replace the Teflon Tape on all threaded connections and fittings.
Copyright © 2022 by E-Rotek Water Systems Co., Ltd.
All rights reserved. No part of this publication may be reproduced, distributed, or transmitted in any
form or by any means, including photocopying, recording, or other electronic or mechanical methods,
without the prior written permission of the publisher, except in the case of brief quotations embodied in
critical reviews and certain other noncommercial uses permitted by copyright law.
