Ross Opengear FED-6943, User Manual, Page: 84 / 92

10–4 • DashBoard Menus Fiber Ethernet Switch Transceivers User Manual (Iss. 04)
Hardware Tab
Table 10.2 summarizes the read-only information displayed in the Hardware tab.
Product Tab
Table 10.3 summarizes the read-only information displayed in the Product tab.
Table 10.2 Hardware Tab Items
Tab Title Item Parameters Description
Hardware
HW Status
OK
Indicates the status of the hardware
including the SFP module. Some
messages displayed are dependent on the
settings in the Alarms Enable tab.
FPGA load invalid
Incomp I/O Module
Current out of spec
Internal Error
SFP Temp Low
SFP Temp High
SFP Power High
SFP Power Low
SFP Tx Fault
SFP Not Detected
Voltage (mV) # Measured input voltage
Current (mA) # Measured current consumption of card
CPU headroom # Processing power available
RAM available #/## On-board processing memory available
Uptime (h) #
Displays the number of hours since the
last reboot of the card
Configuration Bank # Storage count
Table 10.3 Product Tab Items
Tab Title Item Parameters Description
Product
Product # Displays the card name
Supplier Ross Video Ltd.
Board Rev ## Indicates the board revision
Board S/N ###### Indicates the card serial number
Rear Module
# Indicates the Rear Module installed
Rear Module Mismatch
a
a. For cards that support the 8320AR-056 rear module, installing the card with the 8320AR-057 does not provide access to
Ethernet Port 4. For cards that support the 8320AR-057 rear module, installing the card with the 8320AR-056 does not
provide access to Fiber Port 3. You must still configure these ports in the Setup tab of DashBoard, even though they are
not accessible.
Indicates the rear module is either an
8320AR-056 or 8320AR-057 but is not
the one supported by the card
Software Rev ##.## Indicates the software version