- 31
INSTALLATION - GAS CONNECTION
The hob can be built-in ; in class 3 (in compliance with gas regulations EN 30.1.1) ; adjoining
furniture should not be higher than the level of the hob.
This appliance is not connected to an evacuation device for the products of combustion. It must
be installed and connected in compliance with the norms in force in the country of installation.
Particular attention should be given to the availability of ventilation. The turnover of air necessary
for combustion is a minimum of 2 m
3
/h per kW of power.
Gas connection should be carried out in compliance with the norms in force in the country of
installation. A stop tap, a regulator valve or a release valve for propane gas, should be fitted to
the gas supply pipe. Use only taps, regulator valves, connectors and flexible hoses with the
official mark of approval of the country of installation.
Built-in appliance
Butane
Rigid - Flexible pipe with mechanical connectors (1) -
Propane
Rigid - Flexible pipe with mechanical connectors (1) -
Natural
Rigid - Flexible pipe with mechanical connectors (1) -
(1) on condition that the hose is accessible along the whole of its length it should be located so it
cannot be reached by naked flame or affected by combustion gases. Neither should it be near hot
parts of the hob nor anywhere where hot spillages could affect it.
2 POSSIBLES MEANS OF CONNECTION :
• CONNECTION BY RIGID PIPE
Connect directly to the threaded end of the inlet pipe.
• CONNECTION BY FLEXIBLE PIPE WITH MECHANICAL CONNECTOR
Screw the nuts of the flexible pipe directly on to the inlet pipe at one end and the gas
supply stop tap at the other.
We recommend this type of connection.
