ULTRAMATRIX REMOTE INSTALLATION AND OPERATIONS MANUAL
7
Configuring the Unit
The UltraMatrix Remote must first be configured with the network information. The IP address assigned to the unit
and other network information must be entered into the “Configure Login” screen and saved. To configure the Login
information, make sure the unit is connected to a local KVM station and to the network. Turn on the local KVM
monitor and the UltraMatrix Remote unit to configure. The “Connect Login” screen will display. The monitor may
remain blank for approximately 25 seconds before the “Connect Login” screen displays. When the screen displays,
DO NOT
login, hit the F10 key to display the “Configure Login” screen and login in on this screen using the default
User ID, “
admin
” and no password.
The “Connect Login” screen and “Configure Login” screens are very similar. The “Connect Login” screen has a
green background and the “Configure Login” screen has a gray background. The “Connect Login” screen is used to
login to the UltraMatrix Remote as a user locally. Administrator functions are not available to a user. A default
administrator account exists for initial configuration of the unit. Enter the default User ID of “
admin
” (lower case) and
no password.
Configure login
User _
Password
Figure 3. Configure Login screen
When the default User ID of “
admin
” and no password are entered and validated, the network configure login screen
will display (
Figure 4). From this screen, enter the needed network information, the speed / duplex data, and the equipment type
connected to Com1 and Com2. Use the up/down arrow keys to select the item to change. When you select the
speed/duplex field, press the page up key to display the supported values. For Com1 and Com2, also press the
page up / down key to display the supported equipment.
Note: On models where the total number of remote ports are less than the total number of local port
(i.e.RP2-1R2X8U - 1-remote, 2 local), the KVM ports that have no adjacent RJ45 connectors are
considered local ports only. These local ports are connected directly to the KVM portion of the
UltraMatrix Remote and are not routed through the remote access hardware. These ports will not require a
login name and password unless security on the UltraMatrix Remote is configured to require a login.
KVM 2 (local access only) no login required unless configured
KVM1 (Local & remote access) requires a connect login
F1 - Help
F9 - Connect
F10 - Configure
UltraMatrix version 1.35 Copyright 2003 Rose Electronics
