– 76 –
L
The uppermost extraction tower glass must NOT be
placed in the dishwasher. This may cause scratches
in the glass; it may also damage the coating on the
base.
After cleaning:
– Return the filters and the glass into the extraction tower.
– Press the
button after all parts are reinstalled.
– Press the
control key for 3 seconds when the extraction
tower is completly downwards.
9.2.3 Cleaning in the event of spillage into the device
- Follow the steps described in 6.2.1 and 6.2.2.
- Remove the upper collection containers from the tower and
clean if necessary.
- Remove the collection safety and clean if necessary.
- In the case of spillage of large quantities of fluid, slide the
lower collection containers from the underside of the extraction
hood and clean if necessary.
Follow the steps in the reverse order to make the device ready
for cooking again.
– Press the
button after all parts are reinstalled.
10 Troubleshooting minor faults
10.1 Messages on the hob
Code
– there is no cooking pan on the cooking zone
– the cooking pan is not suitable for induction
– the diameter of the bottom of the cooking pan
is too small when compared to the cooking
zone
U
See Chapter 5.3.9 Keep warm (1821)
E
– The electronic system is disrupted.
– Disconnect and reconnect the hob.
– Call the after-sales service
I I
See Chapter 5.3.7 Stop & Go (1821)
(Er03)
The controller keys are covered by liquid or an
item. The symbol will disappear as soon as the
keys are released or cleaned.
E2
The hob has overheated, leave to cool, then
switch back on.
E8
The fan air supply is blocked.
Unblock it.
U400
The hob has not been properly connected to the
network. Check the connection. (1821)
(Er47)
Problem in the device's internal bus system.
If one of these error messages remains visible, you can contact
the after-sales service.
The hob or the cooking zone does not work:
– the hob has been poorly connected to the electrical power
supply
– the safety fuse has blown
– check the locking key has been enabled
– the touch control keys have been splashed with water or fat
– there is an object on the touch control keys
A single zone or all zones are not working:
– the safety device has been operated
– this shall engage when a cooking zone has been left on
unintentionally
– the safety shall also engage when one or more touch control
keys are covered
– a pan is empty and the base has overheated
– the hob also has an automatic power reducer and automatic
shut-down in the event of overheating
The fan continues to operate after the hob has switched
off:
– this is not a defect, the fan is protecting the electronic
equipment
– the fan will stop automatically.
1821_110131_GA1.indd 76
20/08/20 09:40
Det øverste glas i viftetårnet må ikke vaskes i
opvaskemaskinen. Dette kan beskadige glas-
set og belægningen på undersiden.
Efter rengøring:
- sæt filtre og glas tilbage i blæsertårnet.
- Tryk på knappen, når alle dele er installeret
- Tryk på knappen i 3 sekunder, når blæsertårnet er helt
nede
8.2.3 Rengøring efter overkogning / spild
- Følg trinene beskrevet i afsnit 6.2.1 og 6.2.2.
- Fjern de øverste opsamlingsbeholdere fra viftetårnet,
og rengør efter behov.
-Fjern opsamlingssikringen, og rengør efter behov.
¬Hvis du har spildt store mængder væske, skal du fjerne
bundopsamlingsbeholderen fra dampkappen. Rengør
om nødvendigt. Følg trinene i omvendt rækkefølge for at
gøre apparatet klar til brug igen.
Følg trinene i omvendt rækkefølge for at gøre apparatet
klar til brug igen.
- Tryk på knappen, når alle dele er installeret
9. PROBLEM OG FEJLFINDING
9.1 Indikatorer på kogepladen
• Der er ingen gryde i kogezonen.
• Kedlen er ikke kompatibel med induktionskogeplader.
• Kedlens bunddiameter er for lille.
• Elektronikken er defekt.
• Afbryd forbindelsen til kogepladen
• Ring til kundeservice
• En genstand eller væske dækker kontrolknap-
perne. Symbolet forsvinder, så snart du tørrer
eller renser knappen.
Luftindtaget til ventilationen er blokeret, fjern det,
der blokerer det.
Kogepladen er ikke tilsluttet lysnettet. Kontroller
koblingen.
Problemer i enhedens interne BUS-system
Kogepladen er overophedet. Afkøles inden brug
igen
Se kapitel 4.3.7 Stop & Go
Se kapitel 4.3.9 ”Keep warm”
Hvis en af disse fejlmeddelelser vedvarer, skal du kon-
takte kundeservice.
Kogepladen eller kogezonen kan ikke tændes:
• Kogepladen har en dårlig strømforbindelse
• En sikring er udløst.
• Låsefunktionen er aktiveret.
• Touch-knapper er dækket af snavs eller vand.
• Der er et objekt på knappen.
En eller alle kogezoner afbrydes:
• Sikkerhedsfunktionen er aktiveret.
• Du har glemt at slukke for kogezonen, og den har
været tændt i lang tid.
• Én eller flere berøringsknapper er dækket.
• Gryden er tom, og bunden er overophedet.
• Kogepladen har automatisk reduktion af boosternive-
au og automatisk slukning, når den er overophedet.
Fortsat ventilation efter at ventilatoren er slukket.
Dette er ikke en fejl, ventilatoren fortsætter med at køre
for at beskytte de elektriske komponenter på apparatet.
• Emfanget stopper automatisk
- 47 -
Summary of Contents for NOVY PANORAMA POWER 1821
Page 2: ...NO Bruksanvisning 5913 Panorama Pro 1821 110131 GC1...
Page 18: ...NO Bruksanvisning 5913 Panorama Pro 1821 110131 GC1 18 SE Anv ndarmanual...
Page 34: ...34 NO Bruksanvisning 5913 Panorama Pro 1821 110131 GC1 DK Brugermanual...
Page 50: ...50 NO Bruksanvisning 5913 Panorama Pro 1821 110131 GC1 EN User Manual...