FRANÇAIS
ENGLISH
11
UNPACKING
SPECIFICATIONS
WARNING!
The warnings, cautions, and instructions detailed in this manual
cannot cover all possible conditions and situations that occur. It must be
understood by the operator that common sense and caution are factors that
cannot be built into this product, but must be supplied by the operator.
!
22
.
DO NOT DRIVE NAILS
too close to the edge of the workpiece. The
workpiece is likely to split, allowing the fasteners to fly free or ricochet
causing personal injury.
23
.
STAY ALERT
. Keep hands and body away from the path of any potential
fired fastener. Watch what you are doing & use common sense. Don’t
operate any tool when you are tired or under the influence of drugs or
alcohol. Check prescriptions to determine if there could be a problem.
24
.
PREVENT ELECTRIC SHOCKS
. Prevent body contact with grounded
surfaces: pipes, radiators, ranges, and refrigerator enclosures. Before driving
fasteners into walls, floors, or wherever “live” electrical wires may be
encountered, check whether there is a danger of shock.
25
.
KEEP WORK AREA CLEAR
of obstructions.
26
.
STORE IDLE EQUIPMENT
. When the tool is not being used, it should be
cleaned, and stored in a clean dry place out of the reach of children.
27
.
EMPLOYERS
must enforce compliance with the safety warnings and all
other instructions in this manual. Keep it available for use by everyone
assigned to use this tool.
Check immediately that all parts and accessories are included. If anything is
missing or broken, contact your retailer or call 1 (888) 267-7713.
=
Roofing Coil Nailer
=
Safety glasses
=
S3 Hex Key
=
S4 Hex Key
=
S5 Hex Key
=
Air Tool Oil
=
Manual
=
Case
SPECIFICATIONS
=
Shoots standard 7/8”, 1”, 1-1/4”, 1-1/2”, and 1-3/4” (22 mm, 25 mm, 32 mm,
38 mm, 45 mm) x 11 ga. (3.05 mm / 0.120”) flat, full round-head (max. head
diam: (10 mm / 0.39”) roofing coil nails in 120, 15-16 degree wire-collated
rolls
=
Operating pressure: 85-120 PSI / 586 to 827 kPa / 5.9 to 8.3 bar
=
Air consumption: 0.1 cubic foot / 2.8 litres per cycle @ 100 PSI / 689 kPa
=
Nail Capacity: 120 nail coil
=
Air Inlet: 1/4” NPT
=
Tool weight: 5.9 lbs (2.7 kg)
=
Pkg. weight: 9.5 lbs (4.2 kg)
FEATURES
=
Carbide inserts in the nose of the tool prevent wear on the nose and firing
chamber from abrasive shingles
=
Padded rubber hand grip.
=
Non-slip blue finish
=
Re-directable exhaust port
=
Adjustable shingle location guide
070710
