ENGLISH
FRANÇAIS
14
!
!
OPERATING PROCEDURES
The depth to which a nail is driven is controlled by the depth adjustment knob,
reachable through the window in the front of the clear plastic guard. The depth
of drive is factory adjusted to maximum.
Test fire a nail into a sample of the material you will be working on and check
depth. If a change is desired, rotate the adjustment knob clockwise (upward)
to increase the depth, counterclockwise (downward) to decrease it. Test fire
another nail and check depth again. Adjust as necessary.
CLEARING A JAMMED FASTENER
CAUTION
:
Disconnect the tool from the air supply.
1
. Open the feeder cover and the magazine cover. Remove any remaining
fasteners from the nailer.
2
. Use a slender, soft steel rod to push the drive blade to its uppermost
position. Remove the jammed fastener with needle nose pliers.
3
. Follow instructions in Preparing the Tool to reload fasteners.
MAINTENANCE
CLEAN AND INSPECT DAILY
CAUTION
:
Disconnect tool from air supply before cleaning and inspection.
Correct all problems before putting the tool back in service.
=
Wipe tool clean and inspect for wear or damage. Use non-flammable
cleaning solutions to wipe exterior of tool only if necessary.
Do Not Soak
tool
with cleaning solutions. Such solutions can damage internal parts.
=
Inspect trigger and safety mechanism to assure system is complete and
functional: no loose or missing parts, no binding or sticking parts.
=
Keep all screws tight. Loose screws can cause personal injury or damage
the tool.
=
If the tool is used without an in-line oiler, place 5 or 6 drops of air tool oil into
the air inlet of the tool at the beginning of each workday.
SERVICE AND REPAIRS
=
All quality tools eventually require some servicing of replacement parts due
to wear from normal use.
=
If your tool requires service, ask your retailer or call us at 1 (888) 267-7713
for an authorized repair centre in your area. All repairs made by local
authorized repair centres are fully guaranteed against defective material and
workmanship.
=
Some user-serviceable components are described in the Troubleshooting
section. We cannot guarantee repairs made or attempted by anyone other
than authorized agencies.
=
Questions? Feel free to call our technical support department toll-free at
1 (888) 267-7713. In any communication, please be prepared to give all the
information about your tool: model number, type, serial number, etc.
RRN-COIL/11G-001