30
• Now, seal one open edge of the cut foil as follows:
o Position the foil with the flat surface downwards in front of the appliance and place one of the open
foil edges so on the sealing gasket (9) that this open foil edge touches the outside of the gasket for
the vacuum chamber (7).
o The foil must not reach into the vacuum chamber (8) or lie on the gasket for the vacuum chamber (7)
(fig. G and G1).
o Close the cover and turn the function levers (1) to position “READY” (fig. H).
o For sealing, press the button “seal” (2H) (fig. I and I1).
• After the sealing process, release the cover by turning the function levers (1) (fig J).
• Remove the ready bag and check the sealing seam (fig. K).
NOTE:
Make sure the sealing seam is in proper form. A correct seam has to be a flat, even stripe
without wrinkles and not showing any structure.
• Unplug the appliance after use.
Fully-automatic vacuum-sealing with bags
• Fill the bag without making wrinkles or stretching the surface. The area of the sealing seam must be
clean, dry and free from food inside and outside.
• Position the filled bag
with the flat surface downwards in front of the appliance and place the open
edge of the bag in the vacuum chamber (8). Make sure the complete edge reaches into the vacuum
chamber (fig. L and L1).
• Close the cover and turn the function levers (1) to position “READY”. Through the inspection window,
the correct position of the bag inside the vacuum chamber (8) can be checked (fig. M and M1).
• Start the fully-automatic vacuum-sealing process by pressing the button “vacuum & seal” (2D) (fig.
N and N1). The pump extracts air from the bag and the vacuum chamber (8) so that a vacuum is
generated. After the air has been extracted, the bag is sealed. This is indicated by the red glowing pilot
lamp (2B).
• The sealing process can be started early by activating the button “seal”.
• The sealing process is finished when the red LED (2B) stops blinking.
• Release the cover by turning the function levers to position “OPEN” and remove the bag (fig. O).
NOTE:
Make sure the sealing seam is in proper form. A correct seam has to be a flat, even stripe
without wrinkles and not showing any structure (fig. O1).
• Unplug the appliance after use.
