4801-5164J
20 October 2021
40
RS-500 5K Walk-In Cooler Door Installation and Operation Manual
Section 4.2: Component Replacement
Section 4.2.1: Egress Tracks
The egress tracks can be removed as follows:
1. Raise the door to the fully open position.
2. Open the head unit cover, then engage the stand.
3. Turn the Smart Controller power switch to the Off position.
4. Flip the track to the open position, then slide it upward until the tabs clear the slots. Pull the bottom toward the center of the
opening.
5. If you are replacing both tracks, repeat Step 4 on the other track.
The new egress tracks can be installed as follows:
1. Orient the new track so the magnet faces the center of the opening.
2. Lift the top of the track into the crease beside the head unit, then push the track toward the leg of the door. The tabs should
slip into the slots.
3. Allow the track to drop into position until the L-shaped tabs are fully engaged, then rotate the track toward the panels. The
track should now rotate freely.
4. If necessary, repeat Steps 1-3 on the other track.
5. Power the Smart Controller back on using the switch on the controller enclosure.
6. Close and latch the head unit cover.
