6.
Mask Time
Mainly for bass drums so please refer to the explanation
above.
7.
Crosstalk
Same principle as with using pads as as explained above.
Once again, press [SETUP]-[F1 (TRIG)]-[F2 (BASIC)] and the
setting page will appear.
8.
Threshold
If notes are unintentionally sounded even after you have
adjusted the Crosstalk setting, adjust the Threshold. If this
parameter is raised excessively, playing softly may NOT
trigger the TD-10, so keep the value as low as possible.
9.
Curve
If changes in playing dynamics do not produce a natural
change in the volume of the TD-10 instrument, adjust this
parameter.
Adjusting the brightness
of the display
The display contrast is strongly influenced by the location of
the TD-10 and the lighting of the room it’s in. Adjust this
parameter when needed.
Procedure
1.
Press [SETUP]-[F3 (CTRL)]-[F3 (DISPLY)].
The “DISPLAY CONTRAST” page will appear.
2.
Use [INC/DEC] or the VALUE dial to make the setting.
* OR You can do this by holding down [KIT] and rotating the
VALUE dial.
Setting the master equalizer
The master equalizer allows balancing the high, mid, and
low frequencies.
* This equalizer is not applied to the sound which is output from
the DIRECT 1, 2, 3 jacks.
fig.08-08
Procedure
1.
Press [KIT]-[F4 (MAS EQ)].
The “MASTER EQ” page will appear.
2.
Use [CURSOR] to move the cursor to the frequency you
wish to adjust.
3.
Use [INC/DEC] or the VALUE dial to make the setting.
In this page, [F1] will switch the equalizer on/off. Pressing
[F2][F3][F4] will move the cursor directly to the low (LOW),
mid (MID), and high (HIGH) settings respectively.
Parameters
The following parameters can be set for each of the three
points (low, mid, high).
GAIN: -15–0–+15
Specify the amount of boost/cut. Negative (-) settings will
produce a cut.
FREQ (Frequency): 20–500 (Low), 100–4k (Mid),
500–20k (High)
Select the frequency you wish to boots or cut.
The following parameter can be set only for the mid range.
Q: 0.5, 1.0–20 (1.0 steps)
Adjust the width of the frequency range. Depending on the
“Q” value, raising the “GAIN” may boost both the low and
high ranges.
Chapter 7. Settings for the entire TD-10
113
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Chapter 10
Summary of Contents for V-DRUMS TD-10
Page 21: ...Quick Start Quick Start 21...
Page 131: ...Appendices Appendices 131...
