Roland MODELA Pro MDX-500, User Manual

Page: 42 / 72

40
Part 1 Setting Up
Attaching the Brush Adapter for Chip Cleaning for the High-speed Spindle (ZAD-500S)
NOTICE
Use a vacuum cleaner that lets you adjust
the amount of suction and is equipped with
an overload protector.
Always allow a minimum gap of 30 cm
(11-13/16 in.) on the side where the
vacuum hose exits. The vacuum hose
must have sufficient space in which to
move. When the vacuum hose cannot
move smoothly, it can cause malfunctions
or errors in operation.
Items Included with
the ZAD-500S
Vacuum hose
Vacuum duct
Hooks: 2
Tighten
1
2
3
1) Take off the cap and insert
the hook.
2) Secure the vacuum hose
in place.
1) Take off the cap and insert
the hook.
2) Secure the vacuum hose
in place.
Cap
Cap
Vacuum adapter
When the fitting diameters do not match or when the vacuum duct cannot be inserted into the suction opening of the
vacuum cleaner, use strong commercial tape (cloth or electrical) to join the fittings. The duct diameter of the ZAD-
500T is 32 mm (1-5/16 in.).
Attaching the optionally available brush adapter for chip cleaning (ZAD-500S) to the high-speed spindle (ZS-500SH) makes it possible
to take up cutting dust with your vacuum cleaner as you perform cutting.
This is mainly of use when performing cutting using an engraving tool.
Use a commercially available brush
to remove metal cuttings.
Attempting to use a
vacuum cleaner to
take up metal
cuttings may cause
fire in the vacuum
cleaner.