Roland MODELA Pro MDX-500, User Manual

Page: 48 / 72

46
Part 1 Setting Up
When Use the High-speed Spindle
When a high-speed spindle is installed, the range that you can actually cut (in the height direction) is subject to the following restrictions
and is smaller than the maximum cutting range.
- Length of the installed tool
- Position of the XY table where the workpiece to cut is loaded
- If using a spacer for the T-slot table (ZA-600/500 series), the height of the spacer
- If using a depth regulator nose, the stroke of the spindle due to the nut (approx. 5 mm)
If using the depth regulator nose
(nut loosened)
If not using the depth regulator nose
(nut tightened)
105 mm(4-1/8 in.)
(Z-axis movable range
)
55 mm
(2-3/16 in.)
80 mm
(3-1/8 in.)
44.6 mm
(1-3/4 in.)
5.4 mm
(3/16 in.)
62 mm
(2-7/16 in.)
105 mm(4-1/8 in.)
(Z-axis movable range
)
12 mm
(1/2 in.)
X-rail bottom
surface
T-slot table upper
surface when
using a spacer
(ZA-508)
T-slot table
upper surface