Roland MODELA Pro MDX-500, User Manual

Page: 47 / 72

45
Part 1 Setting Up
MDX-500
The maximum cutting area is 500 mm x 330 mm x 105 mm (19-5/8 in. x 12-15/16 in. x 4-1/8 in.). If you selected RML-1 as the
command set, then when converted to coordinate values (step size: 1/100 mm), (x, y, z) = (50,000, 33,000, 10,500).
The actual cutting area differs according to the type of spindle installed.
When Use the High-torque Spindle (ZS-500T)
When a high-torque spindle (ZS-500T) is installed, the range that you can actually cut (in the height direction) is subject to the following
restrictions and is smaller than the maximum cutting range described earlier.
- Length of the installed tool
- Position of the XY table where the workpiece to cut is loaded
- If using a spacer for the T-slot table (ZA-600/500 series), the height of the spacer
X-rail bottom
surface
55 mm
(2-3/16 in.)
80 mm
(3-1/8 in.)
105 mm(4-1/8 in.)
(Z-axis movable range)
22 mm
(7/8 in.)
T-slot table upper
surface when
using a spacer
(ZA-508)
T-slot table
upper surface