Roland MODELA Pro MDX-500, User Manual

Page: 30 / 72

28
Part 1 Setting Up
Installing the Tool
Do not touch the tip of the blade
with your fingers.
Doing so may result in injury.
Do not touch the tool immediately
after cutting operating stops.
The tool may have become hot due to
friction heat and may cause burns if
touched.
Use the correct tool for the material to be cut and the cutting method.
Do not attach the collet without the end mill and tighten with the wrench. Doing so may make it impossible to install
an end mill the next time used.
NOTICE
Use caution to prevent the cutting tool from falling out, otherwise the cutting tool may be damaged.
When installing an end mill, detach the blade holder. If you try to perform machining with the blade holder installed,
the vibration may make it come loose and fall off.
Be sure to use the wrench included with the unit. Using a wrench other than included one may result in
overtightening, making it impossible to remove the collet or damaging the spindle.
Fasten the spindle, tool, and
material securely in place.
Otherwise they may come loose during
cutting, resulting in injury.
Be careful not to drop the collet.
Doing so may cause the collet to deform or break, making it impossible to install a tool.