For a T-slot Table
The installation method differs slightly depending on the type of table. If an optionally available T-slot table is attached, then
follow the procedure below to install.
Procedure
From the rear of the modeling ma-
chine, pull in the magazine unit.
Slide the T-slot nuts into the
grooves.
Loosely tighten the magazine unit
in place.
The T-slot nuts are included with the T-slot
table.
Cap screws
(M8 x 16 mm)
Tighten loosely.
36
Chapter 2 Installation
2-3 Step 2: Attach the Magazine Unit