69
Table 1.0 Command ID
Data Byte
Data Type
Byte details
7 ------- 0
Data Details
$68 (104)=Chorus Control
000000xx
xx =
00=off
01=Type 1
10=type 2
$69 (105)=Portamento Rate
0xxxxxxx
x = Range $00-$7f (0-127)
$6a (106)=Load Sequence
000xxxxx
Seq number to load (1-8) - 0 is do not load Seq
$6b (107)=Voice Mode 1
000wxyyy
yyy = 000=Poly Single (1 voice/note – max 6 notes)
001=Poly Dual (2 voices/note – max 3 notes)
010=Poly Triple (3 voices/note – max 2 notes)
011=Not Used
100=Unison
101=Solo
x =
0 = Rotate Voice allocation
1 = Reassign Voice if possible
w =
0 = Staccato – Envs restarted for each note
1 = Legato - Envs restarted only if all notes off
$6c (108)=Voice Mode 2
00000yyy
yyy = 000=Steal Oldest Voice
001=Steal Newest Voice
010=Steal Highest Voice
011=Steal Lowest Voice
100=Steal Quietest Voice
101=Steal Off (7
th
note ignored)
$6d (109)=Arp Control
00yyy0zz
zz =
00=1Oct,01=2Oct,10=3Oct
yyy =
000=Up,001=Dn,010=U/D,011=Rndm,100=As Played
$6e (110)=AT Control
00000xyz
z =
DCO LFO (1=on)
y =
VCF Cutoff (1=on)
x =
VCA Level (1=on)
$6f (111)=MW Control
00000xyz
z =
DCO LFO (1=on)
y =
VCF Cutoff (1=on)
x =
VCA Level (1=on)
$70 (112)=MW Tone Level
0xxxxxxx
x = Range $00-$7f (0-127)
Note – this effect the MW level in the Tone only. The MW
Midi level is set with the Global Parameter
$71 (113)=Midi Control
0000w0yz
z =
Arp Enable (1=Enabled)
y =
Sequence Enable (1=Enabled)
w =
Hold Enabled (1=Hold On)
$72 (114)=Patch Clock TempoHi
0000xxxx
If this is nonzero it will replace the internal Clock
speed with this temporary value. If this value is zero
the internal clock will remain unchanged.
0-255 = 5-300 BPM
This byte is sent as two nibbles which are combined to
make single 8 bit command.
00 0000yyyy = xxxxyyyy
www.kiwitechnics.com
JX-8P Upgrade User Manual v130
