29
Parameter Editing
Parameter Editing can be done in
three ways. Using midi, using the
front panel or by using the PG-800.
Midi details can be found in the midi
section of this manual.
The PG-800 hardware interface is
quite slow and audible stepping will
be heard on some edits. If this is a
problem then use midi or the front
panel to edit.
All parameters can be edited using
midi or the front panel but only the
parameters on the PG-800 can be
edited using this.
Parameter numbers are in three parts
and contain a 'G', a 'B' and a 'T' number
and will look like 212 for VCF Cutoff for
example. To edit this parameter press
PARAMTER EDIT, GROUP 2, BANK 1
and TONE 2. Then edit the value using
the EDIT slider.
DCO Parameters
111 – DCO 1 Range
121 – DCO 2 Range
112 – DCO 1 Wave
122 – DCO 2 Wave
113 – DCO 1 Tune
123 – DCO 2 Tune
124 – DCO 2 Fine Tune
114 – DCO 1 LFO Amount
125 – DCO 2 LFO Amount
115 – DCO 1 LFO Select
126 – DCO 2 LFO Select
116 – DCO 1 ENV Amount
127 – DCO 2 ENV Amount
117 – DCO 1 ENV Select
128 – DCO 2 ENV Select
118 – DCO 1 Freq Dynamics
131 – DCO 2 Freq Dynamics
132 – DCO 1 Mix
133 – DCO 2 Mix
134 – DCO 2 Mix Envelope Level
135 – DCO 2 Mix Dynamics Level
136 – DCO 2 Mix ENV Select
138 – X Mod
Options are 16', 8', 4' or 2'
(For 32' or 1' use DCO Tune)
Options are Saw, Pulse, Square or
Random
Range is ± 1 Octave in half tone steps
Range is ± 50 Cents
Range is 0-127
Options are LFO1, 2 or 3 and normal or
inverted
Range is 0-127
Options are ENV1,2 or 3 and normal or
inverted
Range is 0-127
Key velocity effects DCO Pitch (up
Only)
Range is 0-127
Range is 0-127
Range is 0-127
Options are ENV1,2 or 3 and normal or
inverted
Options are Off, Sync 1, Sync 2, XMod
www.kiwitechnics.com
JX-8P Upgrade User Manual v130
