35
Seq Key Down Play
432 Sequence Key Down Play
Options are Off or On.
Off = The Sequence will always play
when the Sequence button is on
On = The Sequence will only play
when the Sequence Play button is
enabled and a key is being played.
Use this option with parameter 435 to
control how a sequence finishes.
Seq Auto Transpose
433 Sequence Auto Transpose
Options are Off or On.
When on this parameter will transpose
the sequence tune to a key being
played.
Seq Auto Trans Reset
434 Sequence Auto Trans Reset
Options are Off or On.
This parameter is used with Parameter
433 and will make Sequence Transpose
temporary (off) or latched (on). When
the transpose is temporary the
sequence will revert back to the
programmed tune as soon as the
transpose key is lifted.
Sequence Complete
435 Sequence Complete
Options are Off or On.
This is used in conjunction with the Key
Down play option. When Sequence
Complete is Off the sequence will stop
immediately when the key is lifted.
When SC is set on the Sequence will
run to the point where it loops back to
the start and then finish.
Patch Clock
436 Patch Clock
If this parameter is set to non zero this
setting will override the Master Clock
Rate while the Tone is loaded. If this
parameter is set to zero the Master
Clock Rate will be used.
ARP Step Timing
437 Arp Step Timing
The Arp Clock Timing can be set to 1 of
13 options. These are:
Half Note (48 Clocks/Step)
Quarter note (24 Clocks/Step)
8th note (12 Clocks/Step)
8th note, half swing (14,10
Clocks/Step)
8th note, full swing (16,8
Clocks/Step)
8th note triplets (8 Clocks/Step)
16th note (6 Clocks/Step)
16th note, half swing (7,5
Clocks/Step)
16th note, full swing (8,4
Clocks/Step)
16th note triplets (4 Clocks/Step)
32nd note (3 Clocks/Step)
32nd note triplets (2 Clocks/Step)
64th note triplets (1 Clocks/Step)
www.kiwitechnics.com
JX-8P Upgrade User Manual v130