10
GREY EDIT BUTTONS
MASTER TUNE
BUTTON
The MASTER TUNE button allows the
synth global fine tune to be set.
The Tune is changed by moving the
EDIT slider.
The Master Tune can be set from A395
to A485.
Press Master Tune Again or CANCEL
to exit master tune mode.
MIDI BUTTON
The MIDI button allows the synth
global midi options to be set. These
will be memorised and retained when
the power is turned off.
The button will cycle though the seven
global midi parameters and the value
is changed using the Edit Slider
1) Midi In
– This can be 1-16 or Omni
If omni is set any midi channel is
recognised by the Kiwi-8P
2) Midi Out
- This can be 1-16
3) Seq Midi Out
- This can be 1-16
and will only apply to notes from the
sequencer output
4) Soft Through
– There are four
possible options.
Stop All
– No incoming midi is sent
out the Midi Out
Pass All
– All incoming midi is sent out
the Midi Out
Pass Only Non CC
– All Midi except
CC is passed to Midi Out
Stop Used CC
– All Midi is passed to
Midi Out except CC commands that
are recognised and used by the Kiwi-
8P
5) Program Change Enable
– There
are four possible options.
Off
– No program change is sent or
received
In Only
– Program Change commands
are received but not sent
Out Only
– Program Change
commands are sent but not received
Both In & Out
– All Program
Commands are both sent & received
6) CC Enable
– There are four
possible options.
Off
– No MidiCC is sent or received
In Only
– MidiCC are received but not
sent
Out Only
– MidiCC are sent but not
received
Both In & Out
– All MidiCC are both
sent & received
7) Sysex Enable
– There are two
options
Off
– No sysex is recognised by the
Kiwi-8P
On
– Sysex with correct header
information will be recognised
NAME BUTTON
The NAME button allows the Name of
the currently selected Tone to be
edited. Name editing is temporary
until the Tone is changed and will only
be retained if the Tone is written to
memory.
Editing is done by selecting the letter
to change using the Left & Right Arrow
buttons and using either the Edit
Slider or any button with a letter on it.
E.g. The Bank 1 button can be used
for the letter 'G'.
Once editing is finished control can be
returned to normal mode by any of the
following methods.
1) CANCEL is pressed
2) WRITE is pressed to save the Tone
3) NAME is pressed
www.kiwitechnics.com
JX-8P Upgrade User Manual v130