Roland JX-3P, Manual

Page: 6 / 57

6
Features
• 256 Tones, 8 Sequences & 16 Patterns can be stored and edited, Sequences & Patterns can be
optionally linked to tones. It is also possible to temporarily edit any Tone, Seq or Pattern
•
MidiCC support for all parameters, Midi Sysex support for Tone Dump & Load
• Patch Editor Control of Parameters (requires PE v 4.1 or later), Tones have 85 editable parameters
•
8 separate 122 max step polyphonic sequences. These can be clocked from the internal/external
sequencer clock, Pattern Generator, LFO2 or midi clock divided by
3,4,6,9,12,18,24,36,48,72,96,128,144,168 or 192
•
Polyphonic, Unison and Mono Key Assign Modes
•
Portamento in Unison, Mono & Chord modes
•
DCO Key Assign Detune available in all key modes, DCO 1 & 2 have separate Tune controls (+-
12 semitones)
•
Master Synth Fine Tune adjust
•
Two independent envelope generators
• Two independent Low Frequency Oscillators. LFO2 random2 can be clocked from the sequencer
clock. The Arp, Pattern and Sequence clocks can be optionally sourced from the LFO2
•
16 stored Pattern Generator patterns. These can be clocked from the internal/external clock, LFO2
or midi clock divided by 3,4,6,9,12,18,24,36,48,72,96,128,144,168 or 192. The pattern can be any
length between 2 and 16 steps
•
Pattern Play Mode. This can be faded from no effect to full effect.
•
Aftertouch, Modulation Level and dynamics via midi
• Modulation options include Aftertouch and midi modulations that can be used in any
combination. Each ENV Mod can select from ENV 1 or 2 and is a split control with add (normal)
and subtract (inverted)
• LFO Button can inject mod control to any mod destination(s)
•
LFOs can be plus and minus base note or plus only
•
Bend Lever can be directed to Osc, Filter, LFO Rate and VCA Level in any combination
• Chord Mode. Any chord with up to 6 notes can be set and played from any key
•
Enhanced Parameter editing to allow editing of all 85 Tone parameters and 27 Global Parameters
from the front panel
•
Sequencer, LFO 1 and LFO 2 clocks and voice use can optionally display on the front panel
• Greater speed range and 6 waveforms for LFO1 and LFO2, LFO2 has a second Random mode
that can be clocked from the Sequence Clock
•
The Arpeggiator can be clocked from the internal/external clock, Pattern Generator, LFO2 or midi
clock divided by 3,4,6,9,12,18,24,36,48,72,96,128,144,168 or 192.
•
Arp modes are Up, Down, Up and Down and Random, 0, 1 or 2 octaves
•
Key transpose allows transposition to any key. Sequencer key can be shifted to any key while
playing by using Key Transpose
•
Sequencer can be Started, Stopped & Continued using Midi Commands
•
Sequences can be edited
•
Appeggiator will Output Midi Data and Sequencer can optionally Output Midi
• Chorus has Manual Mode & variable speed
www.kiwitechnics.com 3P Upgrade User Manual v400