Roland JX-3P, Manual

Page: 23 / 57

23
Editing a Patch
The Edit Parameter table on the next
page shows all the parameters that
can be edited with the KiwiTechnics
3P Upgrade.
Use the menu map as a guide to the
editing key sequence. For example to
edit the filter cutoff press Tape then
Edit Write then Bank C then Tone
Button 1 and edit the value using the
Sense Slider
The Groups are identified as follows:
To change from Bank A to Bank AA or
Bank B to Bank BB press the Bank
button twice
Bank A Bank A light on steady
Bank B Bank B light on steady
Bank C Bank C light on steady
Bank D Bank D light on steady
Bank AA Bank A light slow flash
Bank BB Bank B light slow flash
All Parameters are edited using the
Sens control unlike the original 3P
which used the Bank buttons to set
switches. These are now changed
using the Sens slider as well.
Note - The behavior of the Sens
control during parameter editing has
been changed from the way the
original 3P works. When editing a
parameter the current value of the
parameter must be matched before
the Sens Control will have any effect
on the parameter value.
e.g. if the filter cutoff is set to 7 the
Sens must be moved to 7 before it
will begin to edit the setting. This
has been done so that a parameter
will not jump to the Sens setting
which can cause unpredictable and
sometimes unpleasant results.
Raising a control towards 10 will
deepen an effect. Each parameter
being edited is identified by the
Bank A to D buttons and the Tone
buttons 1-16 Flashing.
Switch values are displayed as
follows on the Bank lights.
No lights showing is off
Light 1-16 on
- Setting 1-16
Light 1-16 flashing - Setting 17-32
www.kiwitechnics.com 3P Upgrade User Manual v400