Roland JX-3P, Manual

Page: 13 / 57

13
3P Upgrade Notes
Sens Control The behavior of the Sens control
during parameter editing has been
changed from the way the original
3P works.
When editing a parameter
the current value of the parameter
must be matched before the Sens
Control will have any effect on the
parameter value
. e.g. if the filter
cutoff is set to 7 the Sens must be
moved to 7 before it will begin to edit
the setting. This has been done so
that a parameter will not jump to the
Sens setting which can cause
unpredictable and sometimes
unpleasant results.
The switch settings are no longer
changed using the Bank buttons.
They are now also changed using
the Sens control. See the section
on Parameter Editing for details
on this.
Factory Presets The factory presets have been made
close to the original 3P presets.
Clock Display
Midi Switch
The two LFOs and the Sequencer
clock can display on the front panel.
LFO 1 & 2 will display on the Group
A and Group B buttons and the
Sequence Clock will display on the
Rest button light if enabled.
The 3P should be run with the
protect switch in the center position.
The LFO's will stop displaying
while the 3P is not in normal play
mode and the Sequence Clock
will not display while a sequence
is being edited.
This can be moved to 'Protect off'
to change patches.
The Midi
select position is not used.
Chorus
When the Chorus Upgrade is
installed Chorus Speed and a
Chorus Manual Mode will be
available. The Sense Slider will alter
Chorus Speed when not in edit
mode
Midi Received
Midi data received will flash the Tape
Memory button light if it is
recognized by the 3P.
www.kiwitechnics.com 3P Upgrade User Manual v400