74
Modifying the Sound in Real Time
LFO Osc 1 Pitch Depth
Specifies the depth to which the LFO will modulate the OSC1 pitch.
Value:
-63– +63
LFO Osc 2 Pitch Depth
Specifies the depth to which the LFO will modulate the OSC2 pitch.
Value:
-63– +63
OSC 1/2 Coarse Tune
Adjusts the pitch of the tone’s sound up or down in semitone steps
(+/-4 octaves).
Value:
-48– +48
OSC 1/2 Fine Tune
Adjusts the pitch of the tone’s sound up or down in 1-cent steps (+/-
50 cents).
Value:
-50– +50
OSC Sync Switch
Turning this switch on produces a complex sound with many
harmonics. This is effective when the OSC1 pitch is higher than the
OSC2 pitch.
Value:
ON, OFF
OSC2 Level
Adjust the OSC2 level.
Value:
0–127
Filter Type
Selects the type of filter. A filter modifies the brightness or thickness
of the sound by cutting a specific frequency range.
Value
OFF:
No filter is used.
LPF:
Low Pass Filter. This reduces the volume of all
frequencies above the cutoff frequency (Cutoff Freq).
BPF:
Band Pass Filter. This leaves only the frequencies in
the region of the cutoff frequency, and cuts the rest.
HPF:
High Pass Filter. This cuts the frequencies in the
region below the cutoff frequency.
PKG:
Peaking Filter. This emphasizes the frequencies in
the region of the cutoff frequency.
Cutoff
Selects the frequency at which the filter begins to have an effect on
the waveform’s frequency components.
Value:
0–127
Resonance
Emphasizes the portion of the sound in the region of the cutoff
frequency, adding character to the sound.
Value:
0–127
LFO Rate
Adjusts the modulation rate, or speed, of the LFO.
Value:
0–127
Range (Solo synth range)
Specifies the range in which the pitch of the solo synth will vary.
Value:
2 OCT, 4 OCT, 8 OCT
Chorus Send Level
Sets the level of the signal sent to chorus.
Value:
0–127
Reverb Send Level
Sets the level of the signal sent to reverb.
Value:
0–127
Level
Sets the volume.
Value:
0–127
Fantom-G_r_e.book 74 ページ ２００９年７月２日 木曜日 午後２時５５分
