46
Recording Acoustic Instruments or Vocals
(continued)
5
Select the External mics.
fig.menu-overdub-e.eps
Press the [MENU] button to access the menu screen.
Use the [
] [
] buttons to choose “MIC Select.”
Press the [ENTER] button to confirm your choice.
Use the [+] [-] buttons to choose “External,”
“Ext(MONO),” or “Plug-In Power.”
6
Adjust the input level of the external mics.
On the CD-2u/SD-2u’s left side, set the [MIC LEVEL] switch to its “MANUAL” position.
fig.rec-intmic02.eps
Turn the [MIC] knob to adjust the input level of the external mics.
Adjust the loudness of the sound you’re recording. Since you’re not using the LINE input, turn
the [LINE] knob all the way to the left (off).
While producing the sound that you will actually be recording, turn the [MIC] knob to adjust
the input level.
Adjust the level so that the PEAK indicator located above the [MIC] knob lights briefly at the
loudest moments of the performance or vocal you’ll be recording.
* When using the [MIC] knob or [LINE] knob, you might hear a slight noise when the recording
level changes; this does not indicate a malfunction.
fig.rec-intmic03-e.eps
* If sound from the speakers enters the mic, you won’t be able to adjust the level correctly. While
adjusting the level, either turn the [VOLUME] knob all the way down or turn the speakers off, so
no sound will be produced. Use headphones if you want to monitor the sound that’s being
recorded
Value
Explanation
External
External mics connected to EXT MIC (L, R) are selected.
Ext(MONO)
External mics connected to EXT MIC (L, R) are selected. Audio from left and
right will both be sounded at the center (mono).
Plug-In Power
The plug-in power mic connected to the PLUG IN POWER MIC jack is selected.
Auto
Whenever a plug is connected to an EXT MIC (L, R) jack, the external mics are
selected. If no plugs are connected to the EXT MIC (L, R) jacks, the internal
mics are selected. However, automatic selection will not occur when a plug is
inserted into the PLUG IN POWER MIC jack.
Louder
Quieter
The level meter will move according
to the level of the audio input.
PEAK indicator
At this position
If the sound from the microphone distorted even though you’ve turned the [MIC] knob
down, you can decrease the external mic sensitivity.
At the factory settings, the external mic sensitivity is set to “High.” If the level meter does not
move sufficiently, change this setting to “Low.” For details, refer to the text box “Selecting the
External Mic Sensitivity” on Page 48.
CD-2u_SD-2u_e.book 46 ページ ２０１３年１月２４日 木曜日 午前１１時３４分
