2
Part 2
2-1
ABOUT THE CUTTING AREA ........................................................................................................................ 19
2-2
ABOUT THE BLADE ....................................................................................................................................... 19
2-3
DISPLAY MENUS FLOWCHART .................................................................................................................... 20
2-4
EXPLANATION OF DISPLAY MENU .............................................................................................................. 22
• Determining the type of sheet loaded
[SELECT SHEET] .................................................. 22
• Setting cutting conditions
[1—8] Selecting and storing cutting parameters .... 22
[** cm/s] Setting cutting speed ............................... 23
[*.*** mm] Setting blade compensation .................. 24
[** gf] Setting blade force ....................................... 24
[SMOOTHING] Cutting smooth curves .................. 24
[SHEET WEIGHT] Cutting thicker sheets .............. 25
[UP SPEED] Setting tool movement speed
during tool-up ... 25
• Setting the origin point
[ORIGIN SET] ........................................................ 25
• Rotating the origin point
[AXIS ROTATION] ................................................. 26
• Feed the loaded sheet
[AREA] .................................................................... 26
[AREA UNIT] .......................................................... 26
[PREFEED] ............................................................ 27
• Correct for the cutting distance error based on actual measurement
[CALIB] ................................................................... 27
• Repeating the same cutting - Deletes any data in the replot buffer
[REPLOT] ............................................................... 27
• Selecting the instruction set
[COMMAND MODE] .............................................. 28
• Selecting the connection interface
[INTERFACE] ......................................................... 28
• Setting the protocol for a serial connection
[STOP BIT] Stop bit ............................................... 28
[DATA BIT] Data bit ............................................... 29
[PARITY MODE] Parity check ................................ 29
[BAUD RATE] Baud rate ....................................... 29
[HANDSHAKE] Handshake ................................... 29
• Giving priority to settings from the computer
[TOOL-CHG COMMAND]
Enabling pen change commands ................. 30
[VS COMMAND] VS command (Velocity Select) ..... 30
[FS COMMAND] FS command (Force Select) ...... 30
• Other setting
[ENGLISH/JAPANESE/GERMAN/FRENCH/SPANISH/ITALIAN]
Changing the language used for display ............. 31
[DISPLAY UNIT] Setting the coordinate unit
used for display ...... 31
[DEMO CUTTING MODE] Performing demo cutting ... 31
[UP/DOWN MOVE] Moving the blade .................. 31
2-5
PLOTTING ON PAPER MEDIA ....................................................................................................................... 32
2-6
WHAT TO DO IF..... ......................................................................................................................................... 34
2-6-1 What to do if... ...................................................................................................................................... 34
2-6-2 Error messages .................................................................................................................................... 37
2-7
LIST OF CAMM-GL III INSTRUCTIONS ......................................................................................................... 38
2-8
DEVICE CONTROL INSTRUCTIONS ............................................................................................................. 41
Appendices
Appendix 1 CHARACTER SETS ............................................................................................................................. 43
Appendix 2 LIST OF OPTIONS ............................................................................................................................... 44
Appendix 3 SPECIFICATIONS ............................................................................................................................... 45
Copyright © 1994 ROLAND DG CORPORATION
