27
AUTO PREFEED
<OFF> ON
PREFEED
Display readout
Factory default setting
OFF
Available settings
ON / OFF
Explanation
Set to on for automatic sheet feed at cutting. If this is set to on, when cutting data
is sent from the computer, the plotter will automatically execute cutting after a 1
m (39-3/8") feed.
After the sheet is loaded be sure to feed the sheet by the length needed for cutting
with the “AREA” function. (Some data may cause feed over 1 m (39-3/8") , such
as when the next point of movement is located more than 1 m (39-3/8") to the
rear.)
* If the “AREA” function is used to feed the sheet in advance, the sheet will not
be automatically fed even when “PREFEED” is set to on.
Procedure
At the top menu, press the
MENU
key once. Press
or
to move the
blinking cursor to “SUBMENU” on the right side of the lower line of the display,
and press
ENTER
, then press
MENU
key three times. Use
or
to move the
blinking cursor to “PREFEED” on the left side of the upper line of the display,
and press
ENTER
again.
Use
and
to change the value and press
ENTER
to save the setting.
• Correct for the cutting distance error based on actual measurement
CALIB
Display readout
Factory default setting
0.00%
Settings range
-0.19—0.19%
(in increments of 0.01%)
CALIB X CALIB Y
0.00% 0.00%
Explanation
This makes adjustment for distance over the X or Y axis. There may be a
discrepancy between size of the data sent from the computer and the size actually
cut, and this setting makes adjustment for such errors.
Before making this setting, first measure the results of cutting, compare them with
the data sent from the computer, and then calculate the amount of distance
adjustment.
Procedure
At the top menu, press the
MENU
key once. Press
or
to move the
blinking cursor to “SUBMENU” on the right side of the lower line of the display,
and press
ENTER
.
Next, use
or
to move the blinking cursor to “CALIB” on the right side of
the lower line of the display, and press
ENTER
again. Use
or
to align the
blinking cursor with “CALIB X” or “CALIB Y,” then press
or
to change
the value. Press
ENTER
to save the setting.
• Repeating the same cutting - Deletes any data in the replot buffer
REPLOT
Display readout
Explanation
REPLOT: Repeats the same cutting sequence.
CLEAR: Deletes any data in the replot buffer.
*Once you turn the power OFF, all data that until then was kept stored will be
lost. For this reason, the same cutting cannot be made when you turn power ON
again.
Procedure
At the top menu, press the
MENU
key once. Press
or
to move the
blinking cursor to “REPLOT” on the left side of the lower line of the display, and
press
ENTER
.
To start replotting, move the blinking cursor
or
to “START” and press
ENTER
. To erase the data in the replot buffer, move the blinking cursor
or
to “CLEAR” and press
ENTER
.
REPLOT
START CLEAR
