31
• Other setting
Changing the language used for display
ENGLISH JAPANESE GERMAN FRENCH SPANISH ITALIAN
Display readout
Factory default setting
ENGLISH
Available settings
Explanation
The PNC-1850/1200 is capable of displaying all its menus in either of six
languages, English, French, German, Spanish, Italian and Japanese.
Procedure
While holding down the
MENU
key, turn the power on.
Using the
or
to select. Press
ENTER
to save the setting.
ENGLISH, FRENCH, GERMAN,
SPANISH, ITALIAN and JAPANESE
ENGLISH JAPANESE
GERMAN FRENCH
Setting the coordinate unit used for display
DISPLAY UNIT
Display readout
Factory default setting
MACHINE
Available settings
Explanation
This sets the type of unit for coordinate values that appear on the display. Set this
to “MECHANICAL UNIT” for display in cutting coordinate units (1 = 0.025 mm),
or to “MILLIMETER” for display in millimeters.
Procedure
At the top menu, press the
MENU
key once. Press
or
to move the blinking
cursor to “SUBMENU” on the right side of the lower line of the display, press
ENTER
, then press
MENU
twice. Use
or
to move the blinking cursor to
“UNIT” on the left side of the lower line of the display, and press
ENTER
again.
Change the value with
or
and press
ENTER
to save the new setting.
MACHINE / MILLIMETER
DISPLAY UNIT
<MACHINE> MILI
DEMO CUTTING MODE
Display readout
Factory default setting
—
Explanation
This performs an operation check when the PNC-1850/1200 is not working
correctly.
Procedure
* A computer is not required in order to carry out the self-test.
Refer to “1-4-2 Installing the cutter” and
install a blade holder in the tool carriage.
Hold down the
on the panel while you
turn the power ON.
Load the sheet, following the procedure
described in “1-4-3 Loading the sheet.”
Close the front cover and use the display
menu to select the type of sheet loaded.
After sensing the sheet size, the PNC-
1850/1200 begins demo cutting.
Operation is normal if the figure shown at right is cut.
Performing demo cutting
DEMO CUTTING
UP/DOWN MOVE
Display readout
Explanation
This moves the tool up or down. It also moves the tip of the blade in any of four
directions (-X, +X, -Y, or +Y).
With the tool down, the tool carriage can be moved with the four cursor keys to
cut the sheet.
Procedure
At the top menu, press the
MENU
key once. Press
or
to move the
blinking cursor to “SUBMENU” on the right side of the lower line of the display,
press
ENTER
, then press
MENU
again.
To move the tool up or down, press
ENTER
. To move in the -X, +X, -Y, or +Y
direction, press
,
,
, or
, respectively.
Moving the blade
UP/DOWN->ENTER
MOVE ->CURSOR
