5
1 Cut 50cm/s
0.250mm 30gf
Display
Provides menu display, configuration
preferences, coordinates, as well as
error messages for troubleshooting.
1-3-3 Operation Panel
MENU Key
MENU
Employed to select among the
available menus, or to cancel the
making of a setting at a particular
menu.
Cursor Keys
Used to move the blinking cursor. The
and
keys are also used to
move the sheet, and the
and
keys are used to move the tool
carriage.
ENTER Key
ENTER
Press to enter into a subroutine of the
item selected using the cursor keys or
to confirm (save) the value set in
configuration.
TEST Key
TEST
Pressed to execute a cutting test (Use
to confirm material specifications as
well as cutting speed, blade force, and
blade compensation).
PAUSE Key
PAUSE
When pressed once, this temporarily halts cutting in
progress. Pressing this key again releases the paused state.
Blinking Cursor
Used to select the desired item from the menu. The
key moves it
to the right, the
key moves it to the left, the
key moves it up,
the
key moves it down.
Power LED
This lights up when the power is
switched on.
PAUSE LED
This lights up when the PAUSE key is
pressed to pause the PNC-1850/1200.
1-4 BASIC OPERATION
* In this manual, the sections that explain both the PNC-1850 and the PNC-1200 shown only illustrations of the PNC-
1850. Some details of the PNC-1200 differ from the figure.
1-4-1 Setting Up and Connection
Setting up
Never install this unit in any of the following situations, as it could result in damage:
Places where the installation surface is unstable or not level.
Places with excessive electrical noise.
Places with excessive humidity or dust.
Places with poor ventilation, because the PNC-1850/1200 generates considerable heat during operation.
Places with excessive vibration.
Places exposed to strong illumination or direct sunlight.
For an explanation of how to assemble the unit and the stand (PNS-185/
PNS-121), refer to the “ASSEMBLY INSTRUCTIONS” included with
the stand.
When arranging setup space for the PNC-1850, make sure you have a
space that is at least 1,200 mm (47-1/4") high, 1,600 mm (63") wide, and
750 mm (29-1/2") in depth. For the PNC-1200, a space that is at least
1,150 mm (45-5/16") high, 900 mm (35-7/16") wide, and 750 mm (29-1/
2") in depth is needed to install the unit on the stand.
Since the sheet moves during cutting, make sure the unit is placed on a
stable, sturdy surface. Also make sure the nothing will interfere or block
the movement of the media in any closer than 600 mm (23-5/8") to the
front or behind the unit.
600 mm
(23-5/8")
600 mm
(23-5/8")
