Rohde & Schwarz TSME, User Manual

Page: 17 / 75

Preparing for Use
R&S
®
TSME
15 User Manual 1514.6542.02 ─ 10
2.2 Connecting the R&S TSME
This section describes how to connect the R&S TSME to the other devices in the mea-
surement setup (see also Chapter 1.2, "Measurement Setup" , on page 5).
● Connecting the DC Power Supply ...........................................................................15
● Setting Up the LAN Connection to the Host PC ......................................................16
● Connecting External Devices ..................................................................................21
● Connecting a Kensington Lock ............................................................................... 22
● Connecting Multiple R&S TSMEs to one Host PC (LTE MIMO Setups, Parallel
Usage) .....................................................................................................................23
2.2.1 Connecting the DC Power Supply
The DC power supply connector is on the rear panel of the unit. Voltages from 10 V to
27 V are supported. There is no need to set the used voltage manually.
Possible power cable connections
The R&S TSME can work with the following DC power supplies:
●
Cigarette lighter power supply (for example in a vehicle) using the supplied DC
power cable
●
Optional AC power supply and power cable R&S TSME-Z1 (see Table 1-1 )
●
Proprietary power supply with an adapted power cable
Using the supplied cigarette lighter power supply cable
► To use the power supply from a cigarette lighter, connect the supplied power cable
from the R&S TSME to the cigarette lighter.
Connecting a proprietary power supply
► To use a proprietary DC supply with the R&S TSME power cable, demount the cig-
arette lighter adapter from the supplied power cable and connect the open ends of
the cable to the proprietary power supply. Be sure to respect the correct polarity
(see
Figure 2-4 ).
Connecting the R&S TSME