Rohde & Schwarz TSME, User Manual

Page: 55 / 75

Basic R&S TSME Functions
R&S
®
TSME
53 User Manual 1514.6542.02 ─ 10
●
Simultaneous measurements of GSM, WCDMA, CDMA2000®, 1xEVDO, WiMAX,
TETRA and LTE technologies
●
Calculation of base station locations from scanner measurements via R&S ROMES
or R&S NESTOR software plus GPS position measurements plus high accuracy
PPS
●
Power scans over the entire frequency range from 350 MHz to 4400 MHz
●
Simple scanner setup
The following sections briefly describe the basic requirements for interaction between
the R&S
TSME and the R&S ROMES, R&S NESTOR, or R&S ViCom interface. For
details on using these interfaces see the R&S ROMES, R&S NESTOR, and
R&S ViCom manuals.
4.8.1 Interacting with R&S ROMES
Prerequisites
In order to perform measurements with the R&S ROMES application, the following pre-
requisites apply:
●
R&S ROMES Installation (refer to R&S ROMES manual)
●
R&S ROMES option on dongle inserted (refer to R&S ROMES manual)
●
Required technology options installed on the R&S TSME (see Chapter 1.3.1,
"Technology Options" , on page 8 and Chapter 4.4, "Installing and Managing Soft-
ware License Keys" , on page 46)
●
Software options installed on the host PC (see information on the ROMES product
page on the Rohde
& Schwarz website: https://www.rohde-schwarz.com/product/
ROMES > "Options")
After the R&S TSME has finished booting, start the R&S ROMES software application.
If a connection to this application cannot be established correctly, check the firewall
settings (see
Chapter 6.2, "Guide to Solving Instrument Connection Problems" ,
on page 60)
Automatic firmware updates
Each time R&S ROMES is started, the software automatically compares the firmware
version of the connected R&S TSME with the version currently available on the host
PC. If a newer version is available, it is copied to and installed on the R&S TSME. Up
to two previously installed firmware versions are stored as backups and maintained on
the R&S
TSME ( see also Table 4-1 ). Thus, it is not necessary to perform firmware
updates on the R&S TSME manually.
For details and information on how to configure R&S ROMES and carry out measure-
ments with the R&S TSME, refer to the R&S ROMES manual.
Interacting with R&S ROMES, R&S NESTOR, and R&S ViCom