Preparing for Use
R&S
®
TSME
30
User Manual 1514.6542.02 ─ 10
f) Close the R&S
TSME Device Manager.
3. Move the connector from the second R&S
TSME to the second LAN adapter.
4. Configure the LAN interfaces on the PC so they are located in the same subnets
as the R&S
TSMEs, using the following network settings, as described in
ter 2.2.2.1, "Configuring the LAN Interface on the Host PC"
LAN1:
)
●
IP address
:
192.168.0.1
●
Subnet mask
:
255.255.255.0
LAN2:
●
IP address
:
192.168.1.1
●
Subnet mask
:
255.255.255.0
5. Check the IP connections in the R&S
TSME Device Manager.
All connected and switched on R&S
TSMEs should be displayed.
(If not, see
Using a switch
The following graphic illustrates the setup for two R&S
TSMEs connected to the same
host PC in parallel, using a switch between the PC and the R&S
TSMEs, and a syn-
chronization cable between the R&S
TSMEs (AUX ports). The setup for four
R&S
TSMEs is shown in
.
The optional 5-port Gbit LAN Switch - USB powered R&S TSPC-LS allows you to con-
nect four R&S
TSMEs to the same host.
Prerequisites for the switch
When using a switch to connect multiple R&S
TSMEs to one host PC, the following
conditions apply:
●
1 GBit LAN switch
●
9K Jumbo frame support
●
Dedicated LAN adapter on the host PC to connect the switch to
Connecting the R&S
TSME
