Preparing for Use
R&S
®
TSME
12
User Manual 1514.6542.02 ─ 10
EMI suppression
Electromagnetic interference (EMI) may affect the measurement results.
To suppress generated electromagnetic interference (EMI):
●
Use suitable shielded cables of high quality. For example, use double-shielded RF
and LAN cables.
●
Always terminate open cable ends.
●
Note the EMC classification in the data sheet.
●
Use the supplied DC cable or a DC cable shorter than 3 m.
●
Do not operate the instrument in DC mains.
●
Operate the instrument only with an
active
antenna connected to the [GPS ANT]
connector.
2.1
Unpacking and Setting Up the Instrument
The following section describes how to set up the instrument.
Risk of instrument damage due to inappropriate operating conditions
Specific operating conditions are required to ensure accurate measurements and to
avoid damage to the instrument. Observe the information on appropriate operating
conditions provided in the basic safety instructions and the instrument's data sheet.
Check the equipment for completeness using the delivery note and the accessory lists
for the various items. Check the instrument for any damage. If there is damage, imme-
diately contact the carrier who delivered the instrument. Make sure not to discard the
box and packing material.
Packing material
Retain the original packing material. If the instrument needs to be transported or ship-
ped later, you can use the material to protect the control elements and connectors.
Accessory list
The following items are included with shipment of the R&S
TSME:
●
DC power supply cable with a cigarette lighter connector
●
LAN cable to connect host PC (RJ45 Patch cable CAT6 2m)
●
Active GPS antenna
●
CD-ROM with required R&S
TSME software, drivers, tools, and manual
Unpacking and Setting Up the Instrument
