Rohde & Schwarz SCV8000E/R, System Manual

Page: 134 / 214

Chapter 5 Operating
2104.6536.72 - 5.52 - E-1
3.4 Output Stage: Amplifier Menu
The menu windows in the Amplifier menu are used to make settings for the amplifiers.
The menu windows
The Amplifier menu branches to the following menu windows:
– Status > AMP 1/2 : Status indications for the base amplifier (AMP 1) and possibly the
extended amplifier (AMP 2)
– Setup > Output Power : Used to set the transmitter output power
– Setup > Trimming : Improves the efficiency and balance in case of very different output
power levels for the individual amplifiers
– Service > AMP 1/2 : Parameter indications for the amplifier modules
3.4.1 Amplifier > Status > AMP 1/AMP 2
Number of Amplifiers Selects the system configuration with 1 or 2 amplifiers
– 1: System with a base amplifier
– 2: System with base and extended amplifiers
Tx Mode Sets the transmitter operating mode
The options are as follows:
– Dual Drive + NetCCU: Standby system with 2 exciters and automatic
switchover
– Single Tx + NetCCU: Single transmitter with R&S NetCCU800
– 1+1: Standby system with 1 standby transmitter for 1 active transmit-
ter
– N+1: Standby system with 1 standby transmitter for n active transmit-
ters
– Single Tx: Single transmitter
– xx7000: Upgrade for older transmitter generations
Tx Name Inputs a transmitter name for easier identification
Setting item Explanation