RoboVent Spire MLS-01-5500-10, Owner'S Manual

Page: 43 / 68

ROBOVENT • SPIRE SERIES OWNER’S MANUAL 43
SECTION 900
Maintenance
2. Use a long-handled brush to sweep/
scrap dust loose inside of the arrestor.
Once dust is dislodged, depending on
the composition of the material, either
wipe it out using a rag and industrial
cleaner, or vacuum it out with your
industrial vacuum. (see Figure 33).
3. Ensure inside walls of spark arrestor are
clean and free of any build up to ensure
continued function before putting your
Delta3 back together.
7. Inspect inside filter cabinet for build-up. Brush
the interior walls pushing the dust down into
the containment area.
DO NOT BRUSH THE
FILTERS.
Brushing the filters will cause unseen
damage severely shortening the filter life and
efficiency.
8. Visually inspect filter door gasket. Any damaged,
torn, or loose gasket will need to be replaced.
(see Figure 34).
9. Close filter door.
10. Open dust tray, record percentage full for
reference to help estimate the frequency needed
for proper maintenance.
11. Visually inspect machine to ensure there are no signs
of leakage, and that the latches and hinges are tight.
12. Confirm air pressure on filter regulator located at rear
of unit is set to 85 psi. Suppled air should be clean
and dry. Oil and/or water in the supplied air will
damage the filters. Check the regulator bowl for any
build up. Blow out any build up found by depressing
the button on the bottom. (see Figure 35).
13. Ensure all doors and access panels are closed and
dust tray is secure.
14. Check floor for any dust that may have spilled,
clean as needed.
FIGURE 33
FIGURE 34
FIGURE 35