RoboVent Spire MLS-01-5500-10, Owner'S Manual

Page: 25 / 68

ROBOVENT • SPIRE SERIES OWNER’S MANUAL 25
SECTION 500
Installation
Intake Damper Installation (continued)
• See Chart 1.0 highlighted in yellow is the connections
made to the Intake Damper Din connecter.
• See chart below, highlighted in orange will be the
connection to be made from the Intake Damper
Din connecter.
Notes:
When connections are made, and system is ready
to be tested you can do so by turning system on
and off. When system is on the dampers should
open and when system is off the dampers should
close. If you do not have the same wire colors
from “Figure 23” just make sure the connections
match with “Chart 1.0”. If the dampers are acting in
reverse you must bleed air supplying to the Valve
and swap the Outlet tubes and retest.
FIGURE 24
CHART 1.0: Wiring for 24VAC Coil Voltage Dampers
Terminal Strip wire
# in RV control
panel
VFD Output Din Connecter
terminal #
IDEC Relay Input Fuse holder
41- A1
61 R1B A2
1 (24VAC) 14 (NO)
2 (0VAC) 2 (0VAC)
G (Ground) G (Ground)
11 60 (24VAC)