11
Using the sound system for the
fi
rst time
1. Place your sound system on a
fl
at surface and connect the loudspeakers
to your sound system (see page 9).
2. Fully extend the wire aerial located on the rear of your sound system.
The wire should be fully extended and positioned for optimum reception.
3. Plug the mains lead into the mains socket located on the back of your
sound system ensuring that the plug is pushed fully into the socket.
4. Plug the other end of the mains lead into the wall socket and switch
on the wall socket.
IMPORTANT:
The mains plug is used as the means of connecting
the sound system to the mains supply. The mains socket used for the
sound system must remain accessible during normal use. In order to
disconnect the sound system from the mains completely, the mains
plug should be removed from the mains socket outlet completely.
5. When your sound system is
fi
rst switched on the clock display will
show 0:00 and the unit will enter the standby mode.
6. When a signal has been found, the display will show the correct time.
7. If a signal has not been found it may then be necessary to relocate
your sound system to a position giving better reception. You should
then carry out an autoscan to
fi
nd stations as described on page 13.
USB
AUX IN
L
R
SPEAKER
L
R
