RLE Technologies WiNG-MGR v2, User Manual

Page: 80 / 94

80 WiNG-MGR v2 User Guide 800.518.1519
B.1. Load the Application Firmware
Once the WiNG-MGR’s configuration file and the latest version of firmware files have been
downloaded to a local drive, navigate to the Firmware tab within the Admin menu in the web
interface.
Figure B.2 Admin Menu, Firmware Page - Firmware File Upload
Navigate to the first file using the browse button, and then click on upload for the unit to take
the file. This process takes about 60 seconds to complete.
B.2. Load the Firmware Using TFTP
You can also use TFTP to update the firmware file. Before updating the firmware through
TFTP, the firmware flash application must be exited and then erased. To do this, navigate to
the WiNG-MGR’s configuration menu. Once here, click on the “Exit to Bootloader” button.
Once exited, you will get a bootloader web page at the IP address of the unit. Next, click on
the “Erase Flash” button. The Flash application will be erased.
Note To erase the flash, a special username and password are required. The username is fds (all
lowercase), and the password is rle2tech (all lowercase).
1
Uploading firmware via TFTP requires a TFTP Client. It may be possible to download a
free license TFTP Client from the internet. Consult your IT department to determine a
compatible client program.
2
Verify that your PC and the WiNG-MGR are on the same subnet (LAN).
3
Open your TFTP client. Configure the client as follows.
a
Host = WiNG-MGR’s IP Address
b
Port = 69
c
Block Size = 64, 128, 256, 512, or 1024