Riso CZ180 Series, User Manual

Page: 11 / 92

Before Starting to Use
Paper Recommendations 11
Tips for Better Paper Feeding
To prevent paper jams and misfeeds, follow the directions below:
• When using standard paper, set the Paper Feed Pressure Adjustment Lever to and set the Stripper Pressure
Adjustment knob to the Standard position ( ). Then set the Paper Jump Wing according to the paper size.
( ) p.21)
• When using thin paper, set the Paper Feed Pressure Adjustment Lever to and set the Stripper Pressure
Adjustment knob to the High position ( ). ( ) p.21)
• When using thick paper (such as card stock), set the Paper Feed Pressure Adjustment Lever to but set the
Stripper Pressure Adjustment knob to the Low position ( ). ( ) p.21)
• Always set the Feed Tray Paper Guide and the Receiving Tray Paper Guide according to the print paper
size.( ) p.20)
• Use flat printing paper that is free of folds. If the use of curled paper is unavoidable, place the printing paper so that
the curl faces down.
• Paper may stick to the print drum (cylinder) surface if the top margin is too narrow on the original or if the upper por-
tion of the original uses a large amount of ink. To solve this problem, lower the print position to provide a wider top
margin or reverse the top and bottom of the original. Restart master making and printing from the beginning when
you rotate the original.
Storing Environment
Store printing paper in a level, dry area. Storing the paper in an excessively humid area can result in paper jams or
poor print quality.
After unpacking the printing paper, keep the remaining paper wrapped and store it in a moisture-proof box. It is highly
recommended to put silica gel in the paper storage box.
CZ180_UG.book Page 11 Wednesday, October 31, 2007 6:19 PM