Chapter 7. Setting Guide for each Configuration
7.4.5
Save & Reboot
To reflect the setting to the WiComm-1, click the [
Save & Reboot]
on the Save & Reboot button on the Save &
Reboot page.
Figure 7-27. Ad-Hoc Mode Save & Reboot
If the WiComm-1 is rebooted, the wireless LAN IP is changed into the IP set in Wireless Network Configuration on
the Networks Settings submenu. Before accessing the WiComm-1, perform the ping test with the PC equipped with
a wireless LAN card. If the ping test is normally performed, the wireless LAN of the WiComm-1 is normally
working.
Now, the setting for the WiComm-1 is completed.
Note
Before starting the ping test, a user should access as sysbas, which is the SSID of the WiComm-1,
from a PC or a device equipped with a wireless LAN. If a user sets a certain SSID, the user can
access by using the SSID selected.
7.4.6
Serial Loopback Test
If the above setting is completed and the ping test is normally is performed, connect the serial port of the WiComm-
1 to Loopback. (Connect receive/transmit pins. e.g., connect pin 3 to pin 5 for RS232 communication).
After that, install the Com Redirector program contained in the CD provided to use the serial port of the WiComm-1
like the serial port of a PC.
Connect the COM port registered as the serial port of the WiComm-1 by using the serial communication emulator
program and perform the test.
Note
For detailed installation method of the Com Redirector program, refer to the Com Redirector
Installation Manual contained in the CD provided.
7-27
