Chapter 6. Setting via Telnet
setup wlan scan <60, 50 ~ 200 > (Default: 60 )
y
If you have different Access Points and have enabled roaming, you should also set carefully the
roaming
threshold
, which is the point (in signal strength) at which WiComm-1 search for a new Access Point. If you
set it too low, WiComm-1 will spend to much time with a non optimal AP (getting a poorer throughput), and if
you set it too high the card will waste time searching for a new AP too often.
setup wlan roamts <-75, -90 ~ -50 > (Default: -75 )
y
If receive signal level is lower than Roaming Threshold, WiComm-1 scans the all AP(Access Point) every
Roaming Scanning Period,
6.6.2
Setting WEP
setup wlan wep defkey<passphrase> (Default: 1)
y
Set the key index to be used among four 64-bit/128-bit Hex keys.
setup wlan wep passphrase <passphrase> (Default: NULL)
y
Set the passphase value to be converted into a 64-bit/128-bit Hex key value. However, the Telnet mode does
not support of the dynamic creation of WEP keys. The dynamic creation is available through Web setup
interface.
setup wlan wep [ key1 / key2 / key3 / key4 ] <key> (Default: NULL)
y
Set the key value for WEP 64-/128-bit authentication.
6-9
