Chapter 6. Setting via Telnet
6.5 Serial Commands
Serial commands are used for the setting of serial port communication and operating environment. For the detailed
information on each option, refer to ‘
Chapter 5. Setting via Web
.’
setup serial [ interface / mode / port / name / speed / data / stop / parity /
flow / signal / rip / rport / alive / m
셔
/ login / username / password / reset ]
<var
…
>
Table 6-3. Serial Commands
Command
Default
Description
setup serial 1
interface [rs232 /
rs422ptp / rs422md /
rs485ne / rs485e]
RS232
Set the serial interface of the WiComm-1 in terms of software. The
status of the current interface can be checked via the LED beside
the serial port.
setup serial 1 mode
[com2kxp
/
com98
/
t
cp_server
/
tcp_clien
t
/
tcp_mserver /
udp
_server
/
udp_client]
com2kxp
Select the operating protocol to be used in the serial port.
setup serial 1 port
<port number>
4001
Specify the number of the socket assigned in the port.
This port is used to wait the network socket connection in TCP
server and UDP server mode.
setup serial 1 name
<name>
Port 1
Specify a name that can be identified in the port (up to 16 bytes).
setup serial 1 speed
[150
/
300
/
600
/
120
0
/
2400
/
4800
/
960
0
/
19200
/
38400
/
5
7600
/
115200
/
2304
00
/
460800
/
92160
0]
9600bps
Sets communication speed.
setup serial 1 data
[5 / 6 / 7 / 8]
8
Set the number of the bits to establish a byte.
setup serial 1 stop
[1 / 2]
1
Set the number of stop bits.
setup serial 1 parity
[none
/
odd
/
even]
none
Set the way to check the parity bit.
setup serial 1 flow
[none
/
xon
/
rts]
none
Set the way of flow control.
setup serial 1 signal
[data
/
modem]
data
Set whether to test the signal line for a device connected to the
serial port.
setup serial 1 rip
<IP address>
0.0.0.0
Specify the IP address of the target to be connected in TCP Client
mode.
6-6
