Rion VM-83, Instruction Manual, Page: 65 / 106

55
Serial Interface
Command list
Command Function See page
RMT n1 n2 n3 Select local mode/ remote mode 56
RMT? Get ID number and remote mode status 56
RNG n Set level range 56
UNT n Set measurement mode 57
DET n Set display characteristics 58
SNS n1 n2 n3 n4 Set sensitivity 58
LPF n Set low-pass fi lter setting 59
HPF n Set high-pass fi lter setting 60
CAL n Set calibration mode 61
CAL? Get calibration mode status 61
BAT? Get battery capacity status 61
DOD? Get measurement data 62
DOF n
Output instantaneous value every 0.1
seconds in non-protocol mode
63
MAX n Set maximum hold function to On/Off 64
MAX? Get maximum hold function status 64
PEK n Set peak hold function to On/Off 64
PEK? Get peak hold function status 64
RST Reset hold value 65
CMP n Set comparator function to On/Off 65
CMP? Get comparator function status 65
CMS n1 n2 n3 n4 n5 n6 n7 Make comparator function settings 66
CMS? Get comparator function settings 66
STS? Get setting information 67
Note
Settings made via the serial interface are not mem-
orized for the resume function (see page 20).