40
Serial Interface
Measurement data information message
The measurement data information message contains the result for the
immediately preceding measurement. The timing when this message is sent
depends on the measurement data send mode (S0 or S1).
S0 mode
When a measurement is completed, the data are automatically
sent to the external equipment, provided that data transfer is
possible at that point.
Note
In the mode for automatic sending of measurement
results (S0 mode), the KS-93 automatically transmits
measurement data when the unit receives a "G0" com-
mand.
S1 mode
Measurement data are sent to the external equipment when
the KS-93 receives the measurement data request information
message "Q/D".
The data for one measurement can be sent only once. If there is a measurement
data request while no measurement data are available, only "D/
<EOL>
" is
returned.
When measurement data are sent, the message format is as follows.
Summary of Contents for KS-93
