8
Discharge of Humidity
• Do not directly connect the discharge tube to a ventilator,
etc.
Insufficient air flow from the ventilator might block air discharge and stop
the equipment to stop, and cause humidity to leak or mold to form.
• For optimal function of the machine, the length of dia. 80 mm humidity duct is
recommended not to exceed 8 m and 2 bend. Reduce 2 m when adding one bend.
• Maximum allowable length is 12 m and 1 bend (equivalent to 8 m and 2 bends) for dia.
80 mm humidity duct. Reduce 2 m when adding one bend. Under this condition, the
machine still functions safely and normally, however, the drying time and the frequency
of lint filter cleaning may increase.
• According to the real situation, in case it is not necessary to install the humidity duct,
please use the exhaust humidity top to install at exhaust outlet.
• Use the equipment at a flat, stable and sturdy
location, a location that can sufficiently withstand
the weight of the dryer, and a location that is not
subject to excessive noise or vibration. Using a
spirit level, make sure that the equipment is level.
If the equipment is used at an unstable or tilted location, the
safety interlock might not function properly or the equipment
might tip over and cause an injury. Also, if the equipment is used
tilted towards the front, the front door might open with force and
cause an injury.
This might also damage the building or cause noise.
